×

You are using an outdated browser Internet Explorer. It does not support some functions of the site.

Recommend that you install one of the following browsers: Firefox, Opera or Chrome.

Contacts:

+7 961 270-60-01
ivdon3@bk.ru

Simulation of the depth of hardening of parts made of gray cast iron during processing by surface plastic deformation

Abstract

Simulation of the depth of hardening of parts made of gray cast iron during processing by surface plastic deformation

Nikishkina A.B., Bulychev V.V.

Incoming article date: 01.10.2022

Cast iron occupies one of the most important places among structural materials and is widely used in the manufacture of critical automotive parts.The article examines the possibility of processing gray cast iron by surface plastic deformation (SPD) and the study of its hardening depth in order to control the stress-strain state (SSS) of the surfaces of parts. Modeling is carried out, calculations are close to the real situation, a three-dimensional finite element model is used. The data obtained were analyzed by the least squares method (LSM), graphs were plotted.Also, based on the data obtained, it was found that the relationship between the degree of plastic deformation, the diameter of the indenter and the depth of work hardening is an equation that describes the surface. The carried out researches and the received dependence allow to increase the accuracy of forecasting of results of processing of PPD cast iron.

Keywords: grey iron,plastic deformation, bilinear deformation diagram, indentation depth, spherical indenter