×

You are using an outdated browser Internet Explorer. It does not support some functions of the site.

Recommend that you install one of the following browsers: Firefox, Opera or Chrome.

Contacts:

+7 961 270-60-01
ivdon3@bk.ru

Modeling of the oil pipe distribution process in the well and selection of tool parameters

Abstract

Modeling of the oil pipe distribution process in the well and selection of tool parameters

Parshin S.V., Semenova N.V., Parshina A.A.

Incoming article date: 07.01.2023

TThe modeling of the process of distribution of profile oil pipes in a well by means of a cone punch is considered and the determination of the force necessary for its pushing is carried out on this basis. The normal force for one protrusion of the pipe profile was found. The change in the deformation resistance and profile geometry during distribution is taken into account. The optimal taper angle is determined and the geometric parameters of the punch are selected, including the largest and smallest diameters and its length. A numerical example of calculation based on the obtained formulas is given, which shows the technical feasibility of the process.

Keywords: distribution, oil profile pipes, protrusion force, equilibrium equation, deformation resistance, tool geometry, numerical example