The purpose of investigation is to examine the effect of adaptation to difficult-house physical stress on the regulation of the vertical posture of man. For the analysis of the ability to maintain a vertical position used stabilographic hardware-software complex "Stabilan-1-02" (JSK Rhythm ", Russia). The ability to maintain a vertical position was evaluated in two static positions: 1) the main stand (OS) in the presence and absence of visual information, and 2) dip (PP) in the presence of visual information. Revealed that an increase of physical performance ability to maintain balance in static positions, especially in the complicated conditions (deprivation of visual information and static muscle tension) increases.

Keywords: Sports stabilometry, adaptation, vertical pose

  Various non-invasive assessment of psycho-physiological and emotional state were analyzed: the fractal estimation of speech signals, the analysis of rhythmic EEG patterns and computer stabilometry. The results allowing  prediction of the transition of the individual in a particular state, were obtained and objective criteria for determining the individual personality as a specialist were identified.

Keywords: Emotuonal speech, EEG pattern, attractor, suggestibility

The device for uninterrupted measurement of shaft wearing out by stuffing tightening is offered. The device for investigating sealing tightenings is worked out. Opticoelectronic systems are used for increasing the accuracy of measuring and for the purpose of uninterrupted monitoring in the construction of both devices.

Keywords: tribomonitoring, machines and mechanisms, optoelectronics, wear, seals

Technique for measurement of inductances (L) about 1 nanohenry or less one, is discussed. Two measurements of inductance L are executed. First one is executed for stub length l0, another - for stub length, shortened into N times. Formula for calculation of unknown inductance’ error has been obtained, where determination of unknown L with error closed to meter error has been succeeded by choice of parameters. It is shown that required measurement’s error of initial stub length for N=2 and N=5 is in tens micrometers’ range. Techniques for error’s diminishing have been considered. Estimation for basic stub length of 6,6 mm and 8,3 mm for N=2 and N=5 respectively has been executed. 

Keywords: inductance, least-squares procedure, meter error, stub base

The influence of fine-dispersed mineral adds on the properties of cement stone and concrete has been investigated. The possibility of production of necessary strength concrete with small sand without increasing of standard expenditure of cement has been designed.

Keywords: concrete, strength, small sand, add, mineral powder, cement, reduction, expenditure

Some of the issues of a system approach to the development of composite antifriction coatings and also the phase desordered condition of the surface are considered

Keywords: tribology system, structural-phase disordered condition , composite coating, friction

Submitted manufacturing operations performed at the landfill site TOP, their main types of negative impacts on the environment. The conditions of formation and emission of biogas generated in the interior of the landfill body and having a pronounced toxic effects. The dependence of the specific biogas yield for the period of his active stable generation.

Keywords: Solid waste consumption, landfill disposal TOP, biogas, wet waste, environmental safety

 In the article there are considered the problems arising in the building of systems of diagnostics and recognition, provides methods to detect deviations in functioning of the various objects.

Keywords: Diagnostics, еmpirical mode decomposition, extreme filtering, time-frequency distributions

The article examines the development of biogas production in the Altai region. Indicates the need for wide implementation in ho-agricultural practice of farms renewable energy.  Provides information about the main raw materials and specific yield volumes of fuel out of it. Argued that there is a potential for the construction of facilities for the production of biogas based on large and medium-sized livestock operations. This can provide up to 20-25% of the demand in the Altai region gas fuel. It is noted that the implementation of this project requires coordination of government support measures with the mandatory inclusion of livestock facilities for biogas in the construction or reconstruction of livestock enterprises. Also priority for biogas energy in the Altai region called the creation of biogas plants with low capacity. They can be used by individuals to meet the challenges of energy supply and heating. Refers to the importance of their implementation in some areas Altai region. 

Keywords: biogas, bioenergy, renewable energy, biofuel, energy-saving technology, aricultural region

The paper discusses the features of method of extension of circuit’s operating frequency range of the source and the classical emitter voltage follower (VF). The features of this method based on the effect of the mutual compensation of the parasitic impedances are considered. Problem of improving operation speed of VF with output capacitance and reducing the time of establishment of transient at pulsed input voltage are discussed.
The simulation results of VF in Cadence on model of SiGe integrated transistors are given. This shows that with capacitive load high-frequency cutoff, the time of establishment of transient and the slew rate improved to tens - hundreds of times. 
The results of investigate complement of methods of improving operation speed of the classical stage with a common drain and common collector.

Keywords: operating frequency range, source follower, emitter follower, operational speed, broadband amplifier

Are considered method of reducing one of the most essential components of the voltage offset Uvo operational amplifiers (op-amp), executed on classical architecture with current mirrors, which is linked to the change current gain of base (β) bipolar transistors in conditions of temperature and radiation effects.
To solve this problem in the basic architecture of op-amp is entered special corrective multipole, which will provide low-current asymmetry in coordination of input differential stage (DS). The method is applicable to op-amp, which is inexpedient to make any adjustments to the original structure of the DS. 
The analytical expressions determining basic parameters the compensation circuits Uvo, and also shows the tabular data that simplify the choice of standard functional components of precision op-amps.  

Keywords: microelectronics, circuit design, a differential amplifier, operational amplifier, voltage offset, temperature drift, the effect of radiation on the zero level

The article covers the period from XVII to XIX century in the development of art education, when it loses its elitism and becomes massive. Identifies three major trends that have influenced the formation of pedagogical training bases of graphic activity and color in professional artistic training: academic training system, physics color and secondary school. The period and the basic principles of the formation of European and Russian art training. Determined by the stage of the formation of the world system of artistic training.

Keywords: academic, arts education, training, mass education

The work is devoted to modeling sediment transport in shallow waters. Results of mathematical and numerical modeling can be applied in practice to justify the design and construction of hydraulic structures to predict the formation of the bottom topography (eg predicting sediment transport), to address issues related to the protection of the recorded ports and channels, weather impacts to the design, to determine the optimal routes maritime access channels, etc.

Keywords: mathematical modeling, hydrodynamics, transport of substances, the Navier-Stokes equation of diffusion-convection-reaction

The received results of modelling of a micromechanical sensor of angular speeds and linear accelerations are considered. 

Keywords: microsystm technology, element base, modeling, sensor, gyroscope, accelerometer

Article is devoted to aspects of management, aimed at investigating the nature of organizational conflict in order to identify the causes and possible management. Relevance of the topic emphasized by the fact that the study of conflict, its causes, and the methods and means of management emerged relatively recently and now, when the Russian economy is going through a stage of radical reform, this aspect of management is of interest for many researchers. Since the conflict in terms of joint activities of people are able to reduce labor productivity, it is necessary as soon as possible to anticipate. Particularly noteworthy are the management of organizational conflicts, as in the current economic development organization is a key participant in the economic relations and the conflicts that arise in this subject in need of early detection and effective management.

Keywords: organizational conflict resolution, management, conflict management, the concept